Extreme help needed for a novice!!!

[john5862]

I am a electrical inspector, and I spend too much time using a pen to complete mt paperwork. I am sure that there is an easier way using excel, I just can't figure it out. I enter the same data on every application (for inspection) that I do...but frequently I need to print out a seperate report. I bet that there must be some way to repeat the data on a seperate sheet...I am just not sure.

I am so confused that I can't even frame a proper question...hopefully some one will have pity enough to baby sit me!

Is there a way to enter the data ONCE and have reports generated from this input.

Any help would be appreciated

[Carim]

Hi,

Do not worry ... we all started not knowing a lot ... !!!

In the destination cell,
type sign =
then go to the source cell
once properly positionned
press enter ...

That's it ...

HTH
Carim

[john5862]

Thank you so very much...I figured that there was a solution, I just didn't realize that it would be so simple!

Thanks again,
john5862

[Carim]

Welcome to XL ...

Thanks for the feedback

Carim