Thank you for considering my problem!

Only have had this issue since going from Excel 32 bit to Excel 64 bit (December 2022).

The issue:
  1. Running code and come to a Stop i placed.
  2. Start to inspect line-by-line using F8.
  3. I get to a point that i wish to let the code Run again and press F5 or the green arrow.
  4. Only progresses line-by-line.


For example, considering the following code-

Please Login or Register  to view this content.
If i place a Stop on the third line (lCtrOut = lCtrOut + 1), when it comes to this line and i hit F5, the code runs until the condition of the preceding line is once again met and comes to a Stop once again on the third line. If instead of pressing F5 at that point i press F8, then when i wish the code to resume running by either pressing F5 or the green arrow, either one acts as if i pressed F8 and will only advance line-by-line.

I don't know if i need to go back to 32 bit (i had been avoiding 64 bit for quite some time as even MS was advising against it for quite a while) or if i am just doing something stooooopid!

Many thanks,
-Bruce