Update Code to work between 2 files

[dkenebre]

How do I update the following code and any code to work between 2 files. I will run the program from the original document (called "Rundw") within sheet1. I need to move sheets 11 - 14 to another file called "Run_database"
"For i = 11 To 14
Set rng = Sheets("Sheet " & i).Range(rngArray(i - 11))"

Sub test2()
Dim r As Range, c As Range, rngArray, Data As Range, rng As Range
Dim i As Integer, ii As Integer
Set Data = Sheets("sheet1").Range("ck133:dt144")
rngArray = Array("D5:IT7", "D5:IT28", "D5:IT144", "D5:IT645")
For i = 11 To 14
Set rng = Sheets("Sheet " & i).Range(rngArray(i - 11))
For ii = 1 To rng.Columns.Count Step 2
For Each r In rng.Columns(i)
Set c = Data.Find(what:=r.Value, looat:=xlWhole)
If Not c Is Nothing Then r.Offset(, 1) = r.Offset(, 1) + 1
Next
Next
Next
End Sub

Here is the same reference from another code that needs to be updated the way
"a = Sheets("sheet " & 11 + n).Range(rngArray(n)).Value"

[JGeniti]

Have you tried creating an Add-In that houses all of your code and then
referencing the Add-In from each file?

[dkenebre]

No I have not done that, However, that sounds like an interesting concept. How do I do I set it up, according to my posted example?
and does this mean I would not have to change/update the code, just have both files open at the same time while executing the code?

[JGeniti]

The best way to utilize an add-in would be to open up a blank workbook
and transfer all of your code from the original workbook.

Save the new workbook as an .xla file. This makes it an add-in.
Then you would need to go into your original workbooks and delete all
of the code so that it doesn't conflict with the add-in.
Once the code is deleted you will need to go to Tools > References and
browse for the new add-in file that you just created.

You will need to setup the reference for all of the workbooks that you
would like to utilize the code library in the add-in.

Hopefully this was helpful.
James

[dkenebre]

Thanks for the update. Can I just copy, then delete the code as instructed for only the codes that I want to work between the 2 files and leave the remaining code within the original workbook and the procedure will still work?