Thanks to the wonderful help of everyone on the forum, I've almost finished my project; however, I have one last bit of code I can't figure out.
The code unprotects the sheets to run the macro properly (to avoid a nasty GoTo error). It also reprotects the sheets after the macro has run its course...except, if the user selects "No" the sub ends without reprotecting the sheet. This is my last bit of code & any help is greatly appreciated!Please Login or Register to view this content.
By the way, the Open Event has a UserInterfaceOnly protection for the entire workbook. (See note below for reference)
By the way, much thanks to Forum Moderator shg. Without his patience and assistance, I never would have gotten this far (I probably would have thrown in the towel!)
I have attached my somewhat lame project for all to try to understand.
Bookmarks