Hi everyone,
I am hoping to get some help with programming 2 macros in a bank reconciliation sheet I am trying to create.
Basically the data consists of two sets: the ledger side and bank side. Both sides consists of multiple columns that include date, description and amount.
The following two situations can occur and which need to be covered with a macro.
Many to one matching
When we make payments to say 100 different suppliers at once, the ledger side will show 100 lines with the different amounts. However on the bank side it will only show one line with a total amount for the transaction. As the description on the ledger side is the same for all transactions done at the same time, it should be possible to have a macro add these lines and compare the total with entries on the bank side. Once a matching amount has been found, the macro should place an ‘x’ next to all entries on the ledger and bank side, in order to show that these transactions have been reconciled.
Partial cell matching
In this case we are only dealing with one line on both the ledger and bank side. The issue is that the description does not always perfectly match with one another. The ledger side might say ‘Brown Corp.’ and the bank side might say ‘Brown Corporation’. I want to come up with a macro that can recognize this partial match and still reconcile the lines by placing a ‘x’ to both the ledger and bank entry. The match however should be done with a combination of description, date and amount as several different bookings might be done for the same supplier in the same month.
I hope the above descriptions of what I am looking for are clear. Any suggestions on how to accomplish this are more than welcome. Looking forward to your input.
Thanks,
Maarten
Bookmarks