I have lurked and learned but now this is beyond me-Attached is a sample file - The tab Data is where I start the macro and it is the file( after I have cleaned it up) that I get once a week-I added Column K/L-Blank Count Sheet Format is where the macro puts the info- count sheet is what I want it to look like- Old version is how I used to present the sheets-using subtotals etc-See the print preview to see what old ver and sample look like--
This macro below starts in data and puts Column K / L on the blank and then fills them in. Field 1-5 is all one loc sequence -I have the macro going the first few steps what I have been pulling my hair out attempting to do is --If the part# stays the same keep putting the locations under each other-As I show on Count Sheet and when the part# changes put a page break in and start over again with the new part# and assorted info. The file I get each week to do this with will have from 150 to 200 part #'s. I need a page for each--Each part has from 1 to 10 location's ( The loc consists of Field1-5 alfa-numeric )
This is what I have so far----
Any help at all would really be appreciated as I need to push one of these out per week--
Paul
Bookmarks