Hi all,
I'm pretty sure there is a way to custom define this but I'm very confused.
I need to plot based on the following criteria and so far it looks like this:
s/n | control s/n | metering taper 1 | metering taper 2 | metering edge
break 1 | meb2 | [drain edge taper and break 1 and 2 also]
But eventually I'm going to have to take averages and then attempt to plot
out. I'm going to need to make 4 graphs as seen here, metering taper and
metering edgebreaks as well as the drain edges. Eventually I may need to add
more to metering tapers (like a 3rd or 4th catagory) If there is a simpler
way please help me out. I'm confusing myself more and more by the minute.
Restating my issue. I'm going to need to try to make charts for the 4
catagories but I will also need to go through every serial number and get an
average for the values and then plot that. Any ideas? I'm not sure how many
parts I will be dealing with here, shouldn't be too many.
I'll try to clarify anything if it doesn't make sense, just let me know.
Thank you,
John
Bookmarks