Hi guys,
My code for my project was developed based on Pikes code in http://www.ozgrid.com/forum/showthre...=168472&page=2
I tested my code with an equipment that it comes with a "Trasnfer Data" button on it (this sends the data from the serial port to a specified cell in excel), but, now, I'm trying to create a button in excel, which will do the same thing as the "Transfer data" send to command to the serial port to get data off the equipment and input into a specific cell (say B5).
Here's the code i have for the button, but i kept getting error message about the #COM1file
Hope its make sense for you. Thanks.
Regards,
Xin
Bookmarks